| |
- GENERAL SUPPORT MAINTENANCE
TEST SET, RECEIVER AN/ARM-180
- SAFETY STEPS
- WARNING
- Table of Contents
- HOW TO USE THIS MANUAL
- TEST SET, RECEIVER
AN/ARM-180
- CHAPTER 1. INTRODUCTION
- DESTRUCTION OF ARMY
ELECTRONICS MATERIEL.
- Section II. EQUIPMENT
DESCRIPTION AND DATA
- EQUIPMENT DATA.
- EQUIPMENT DATA-continued
- SAFETY, CARE, AND HANDLING.
- SYSTEM OPERATION.
- SYSTEM OPERATION-continued
- MICROPROCESSOR (CPU)
OPERATION.
- FRONT PANEL ASSEMBLY A1
OPERATION.
- AUDIO MODULATION GENERATOR
OPERATION
- LOCALIZER AND GLIDE SLOPE
MODE
- RF SECTION OPERATION.
- RF FREQUENCY SELECTION
- POWER SUPPLY ASSEMBLY
OPERATION.
- CHAPTER 2. MAINTENANCE
- INITIAL POWER ON,
SELF-TEST, AND OPERATIONAL CHECK.
- PROCEDURE
- PROCEDURE-continued
- FREQUENCY RESPONSE
PERFORMANCE TEST.
- MODULATION TONE DISTORTION
PERFORMANCE TEST.
- 9960 FM DEVIATION
PERFORMANCE TEST.
- VOR RADIAL ACCURACY
PERFORMANCE TEST.
- PROCEDURE
- LOC DDM PERFORMANCE TEST.
- PROCEDURE-continued
- GLIDE SLOPE DDM PERFORMANCE
TEST.
- PROCEDURE
- AM MODULATION PERFORMANCE
TEST.
- POWER SUPPLY PERFORMANCE
TEST.
- PROCEDURE
- Section III TROUBLESHOOTING
- HOW TO USE THE
TROUBLESHOOTING CHARTS-continued
- TROUBLESHOOTING CHARTS.
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 1 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 2 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 3 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 4 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 5 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 6 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 7 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 8 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 9 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 10 of 11)
- CHART 2-1. Performance Test
Failure Troubleshooting (Sheet 11 of 11)
- Section IV ALINEMENT AND
ADJUSTMENT PROCEDURES
- AUDIO TONE LEVEL ALINEMENT.
- PROCEDURE-continued
- AM MODULATION ADJUSTMENT.
- PROCEDURE-continued
- ANALOG CARD A2A2 +12 VDC
REGULATOR ADJUSTMENT.
- PROCEDURE
- POWER SUPPLY ALINEMENT.
- PROCEDURE
- RF OUTPUT FREQUENCY
ALINEMENT.
- RF OUTPUT LEVEL ALINEMENT.
- VOR RADIAL ADJUSTMENT.
- PROCEDURE
- AUDIO TONE FREQUENCY
ALINEMENT
- Section V GENERAL SUPPORT
MAINTENANCE PROCEDURES
- GENERAL-continued
- DUST COVER REPLACEMENT.
- FRONT PANEL ASSEMBLY A1
REPLACEMENT
- POWER SWITCH S54
REPLACEMENT.
- SELF TEST SWITCH S53
REPLACEMENT.
- FRONT PANEL HANDLE
REPLACEMENT.
- RF MODULATOR ASSEMBLY A3
AND SYNTHESIZER ASSEMBLY A4 REPLACEMENT.
- INSTALLATION
- POWER SUPPLY ASSEMBLY A5
REPLACEMENT.
- REMOVAL
- CONTROLLER/AUDIO ASSEMBLY
A2 REPLACEMENT.
- POWER SUPPLY FUSE A5A1F1
REPLACEMENT.
- POWER SUPPLY FAN B1
REPLACEMENT.
- REMOVAL
- WIRE HARNESS ASSEMBLY
REPLACEMENT.
- REMOVAL
- FRONT PANEL PUSHBUTTON
SWITCH REPLACEMENT.
- REMOVAL
- INSTALLATION-continued
- ATTENUATOR ASSEMBLY A6AT1
REPLACEMENT
- REWIRING TEST SET FOR 230
VAC OPERATION.
- REWIRING TEST SET FOR 230
VAC OPERATION-continued
- RF OUTPUT CONNECTOR A6J5
REPLACEMENT.
- APPENDIX A. REFERENCES
- APPENDIX B. EXPENDABLE
SUPPLIES AND MATERIALS LIST
- EXPENDABLE SUPPLIES AND
MATERIALS LIST
- GLOSSARY
- INDEX
- INDEX-continued
- INDEX-continued
- INDEX-continued
- FO-1. Wiring Harness,
Schematic Diagram.
- FO-2. System Operation
- FO-3. Front Panel Assembly
A1, Schematic Diagram
- FO-4. Controller/Audio
Assembly A2, CPU Board Assembly A2A1, Schematic Diagram
- FO-5. Controller/Audio
Assembly A2, Analog Board A2A2, Schematic Diagram
- FO-6. Controller/Audio
Assembly A2, TDM Board A2A3, Schematic Diagram
- FO-7. Power Supply Assembly
A5, Schematic Diagram
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- TM-11-6625-2975-40
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- DISTRIBUTION
- Blank Page
|
|