CHAPTER 1 INTRODUCTION
Figure 1. M5 test set.
Figure 2. Hand driven reciprocating pump assembly--side view.
Figure 3. M5 test set fittings.
Section II. DESCRIPTION AND DATA
Figure 4. Identification.
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
Figure 5. Controls.
Section II. OPERATION UNDER USUAL CONDITIONS
Connecting Items To Be Tested to Test Set
Connecting Items To Be Tested to Test Set - Continued
Test Procedures
Test Procedures - Continued
Figure 6. Fuel tank (M2A1 flume thrower or MS riot control agent disperser) attached to test set for volumetric test.
Figure 7. M9 fuel tank attached to test set for volumetric test.
Figure 8. Pressure tank (M2A17 flame thrower or MS riot control agent disperser) attached to test set for volumetric test.
Figure 10. High pressure sphere assembly (with pneumatic hose assembly) attached to test set for hydrostatic test.
Figure 10. High pressure sphere assembly (with pneumatic hose assembly) attached to test set for hydrostatic test.
Figure 11. M8 hose and M7 flame gun connected to M2A1 fuel tank attached to test for hydrostatic test.
Figure 12. M8 hose and M7 flame gun connected to M9 fuel tank attached to test set for hydrostatcic test.
CHAPTER 3 MAINTENANCE INSTRUCTIONS
Section IV. REPLACEMENT OF WORN PARTS
Figure 13. Replacing pressure release control lever preformed packing.
Figure 14. Replacing pump chamber and low-pressure plunger packing.
Replacing Defective Test Stand Assembly Components
CHAPTER 4 SHIPMENT, LIMITED STORAGE, AND DEMOLITION TO PREVENT ENEMY USE
REFERENCES
BASIC ISSUE ITEMS LIST
MAINTENANCE ALLOCATION CHART
Explanation of Format
Figure 1. M5 test set.
Figure 2. Hand driven reciprocating pump assembly--side view.
Figure 3. M5 test set fittings.
Section II. DESCRIPTION AND DATA
Figure 4. Identification.
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
Figure 5. Controls.
Section II. OPERATION UNDER USUAL CONDITIONS
Connecting Items To Be Tested to Test Set
Connecting Items To Be Tested to Test Set - Continued
Test Procedures
Test Procedures - Continued
Figure 6. Fuel tank (M2A1 flume thrower or MS riot control agent disperser) attached to test set for volumetric test.
Figure 7. M9 fuel tank attached to test set for volumetric test.
Figure 8. Pressure tank (M2A17 flame thrower or MS riot control agent disperser) attached to test set for volumetric test.
Figure 10. High pressure sphere assembly (with pneumatic hose assembly) attached to test set for hydrostatic test.
Figure 10. High pressure sphere assembly (with pneumatic hose assembly) attached to test set for hydrostatic test.
Figure 11. M8 hose and M7 flame gun connected to M2A1 fuel tank attached to test for hydrostatic test.
Figure 12. M8 hose and M7 flame gun connected to M9 fuel tank attached to test set for hydrostatcic test.
CHAPTER 3 MAINTENANCE INSTRUCTIONS
Section IV. REPLACEMENT OF WORN PARTS
Figure 13. Replacing pressure release control lever preformed packing.
Figure 14. Replacing pump chamber and low-pressure plunger packing.
Replacing Defective Test Stand Assembly Components
CHAPTER 4 SHIPMENT, LIMITED STORAGE, AND DEMOLITION TO PREVENT ENEMY USE
REFERENCES
BASIC ISSUE ITEMS LIST
MAINTENANCE ALLOCATION CHART
Explanation of Format
