TM 5-6350-275-24&P
3-98. REPLACE CCTV CAMERA AND ENVIRONMENTAL ENCLOSURE ASSEMBLY TC306E/EX. (Figure 3-50).
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
General Safety Instructions:
Screwdriver, Flat tip (Item 7, App B)
Remove all jewelry while working on
Materials/Parts:
equipment.
CCTV Camera /w Lens in Pressurized
Environmental Enclosure
WARNING
Shut off power source before attempting to disconnect, service, or connect wires or cables.
Failure to do so may result in serious injury or death.
a. Removal
(1) Remove input cable from connector (2) and camera enclosure (1).
(2) Loosen clamp holders (3) using a flat tip screwdriver and remove camera and environmental enclosure from
mounting bracket (4).
b. Installation
(1) Insert camera and environmental enclosure in mounting bracket (4) and tighten down with two screws on clamp
holders.
(2) Connect input cable to connector (2) on camera enclosure (1).
Figure 3-50. Removal and Replacement of CCTV Camera and Environmental Enclosure Assembly (TC 306 E/EX)
3-190