TM 5-6350-275-24&P
3-47. REPLACE REMOTE AREA DATA COLLECTOR PANEL ASSEMBLY
(EXTERIOR). (Figure 3-39 and FO-6).
This task consists of:
a. Remove
b. Install
INITIAL SETUP
Tools:
General Safety Instructions:
Screwdriver, Flat tip (Item 6, App B)
Remove all jewelry while working on
Screwdriver, Flat tip (Item 7, App B)
equipment.
Socket Set (Item 11, App B)
Wire Cutters (Item 24, App B)
Wear ESD wriststrap while handling electronic
assemblies.
Materials/Parts:
Exterior RADC Assembly
WARNING
Shut off power source before attempting to disconnect, service, or connect wires
or cables. Failure to do so may result in serious injury or death.
a. Removal
(1) Open and remove front access cover from NEMA 4 enclosure.
(2) Remove red and black slip-on lugs from 12 v battery (6) and remove battery from enclosure.
(3) Remove ac input power cord from power source.
(4) Remove slip-on terminal strip from TB50 (FO-6 sheet 1) on Stargate PWA (10).
(5) Remove comms cable from DLP2 terminal (8).
(6) Remove four bolts (11) holding panel assembly (1) to NEMA 4 enclosure.
(7) Remove panel assembly (1) from enclosure.
b. Installation
(1) Place panel assembly (1) in NEMA 4 enclosure and secure to standoffs with four bolts.
(2) Connect comms cable to DLP2 terminal (8).
(3) Connect slip-on terminal strip to TB50 (FO-6 sheet 1).
(4) Connect ac input power cord for power receptacle (7) to AC power source.
(5) Place 12 v battery (6) in enclosure and connect red and black slip-on lugs to battery terminals.
(6) Place front access cover on NEMA 4 enclosure and secure it.
(7) Download the RSE data to stargate 5000 PWA (19). (See paragraph 3-132 for RSE download procedures)
and request download from PMC Operator.
3-127