TM 5-6350-275-24&P
3-45. REPLACE TAMPER SWITCH.(Interior) (see Figure 3-38).
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
General Safety Instructions:
Screwdriver, Flat tip (Item 6, App B)
Remove all jewelry while working on
equipment.
Equipment Condition:
Input power removed
Wear ESD wriststrap while handling electronic
Enclosure access cover removed
assemblies.
Materials/Parts:
Tamper switch
WARNING
Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do
so may result in serious injury or death.
a. Replace
(1)
Tag and remove the two slip-on connectors (31) from Tamper Switch (30), by holding and pulling out on
connectors.
(2)
Using a flat tip screwdriver, remove the two screws (33) and flat washers (32) holding Tamper Switch (30) to
enclosure.
(3)
Remove Tamper Switch from enclosure.
a. Installation
(1)
Align Tamper Switch up with enclosure mount (13) and secure with two screws (33) and flat washers (32).
(2)
Connect the tagged slip on connectors (31) to Tamper Switch (30).
(3)
Connect AC adapter to power source.
(4)
Replace enclosure cover and secure.
3-124