|
|
TM 11-7010-201-12/ET821- AA-OMI-010/E154 MTS/TO 31S5-2TSQ73-1
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Paragraph
Section
Paragraph
Section
I
Measurement of Voltage at Test Points
Common Tools and Test Equipment; Special
on Circuit Cards . . . . . . . . . . . . . . . . . . . .5-16
Tools; Test, Measurement, and Diagnostic
Measurement of Voltage Across Pins
Equipment (TMDE); Support Equipment; and
Repair Parts
of DC Power Cable . . . . . . . . . . . . . . . . .5-17
Common Tools and Test Equipment . . . . . . . 5-1
Connection of Jumper Between Pins
Special Tools, TMDE, and Support
on J7 Connector . . . . . . . . . . . . . . . . . . . .5-18
Equipment . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
IV Maintenance Procedures
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . 5-19
II
Indicator Lamp Removal and Replacement .5-20
Service Upon Receipt
MTS Component Access . . . . . . . . . . . . . . 5-21
Unpacking MTS . . . . . . . . . . . . . . . . . . . . . . 5-4
Checking Unpacked Equipment . . . . . . . . . . . 5-5
Circuit Card Assembly Removal and
Replacement . . . . . . . . . . . . . . . . . . . . . . 5-22
Signing for Equipment . . . . . . . . . . . . . . . . 5-6
Installation Instructions . . . . . . . . . . . . . . . . . . 5-7
DC/DC Converter Removal and
Electrical Cable Connections . . . . . . . . . . . . . 5-8
Replacement . . . . . . . . . . . . . . . . . . . . . . 5-23
Test Set Probe Assembly Sacrificial
Preliminary Checks . . . . . . . . . . . . . . . . . . . 5-9
MTS Self-Test Procedure . . . . . . . . . . . . .5-10
Connector Removal and
Replacement . . . . . . . . . . . . . . . . . . . . . . 5-24
Ill
Troubleshooting
Power Supply Fuse Removal and
Introduction . . . . . . . . . . . . . . . . . . . . . . . . .5-11
Replacement . . . . . . . . . . . . . . . . . . . . . . 5-25
Fault Isolation Procedure . . . . . . . . . . . . . . 5-12
Repainting and Refinishing . . . . . . . . . . . . 5-26
Removal/Replacement of LRU . . . . . . . . .5-13
Surface Preparation . . . . . . . . . . . . . . . . . . 5-27
Verification That Malfunction Has Been
Surface Coating . . . . . . . . . . . . . . . . . . . . . . 5-28
Removed . . . . . . . . . . . . . . . . . . . . . . . . . .5-14
Measurement of Voltage at Pins of
J7 Connector . . . . . . . . . . . . . . . . . . . . . .5-15
Section I. COMMON TOOLS AND TEST EQUIPMENT; SPECIAL TOOLS; TEST,
MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); SUPPORT
EQUIPMENT; AND REPAIR PARTS
5-1. COMMON TOOLS AND TEST
EQUIPMENT.
The Tools and Test Equipment Table lists the
common tools and test equipment used with the MTS
for organizational maintenance. (Additional
information is in the Maintenance Allocation Chart
(MAC), in Appendix B.)
TOOLS AND TEST EQUIPMENT TABLE
Nomenclature
NSN
Extractor, Printed Circuit Card (Litton)
5999-00-407-5062
Tool Kit, Electronic Equipment TK-101/G
Supplementary Tool Kit, OL
6625-00-060-6804
Digital Voltmeter, AN/USM-451
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |