Section II. OPERATING INSTRUCTIONS - TM-9-4940-403-14-P0013

OPERATING INSTRUCTIONS

INTRODUCTION

The following operating instructions (Paragraphs 2-3 and 2-4)

are identical to those which are permanently affixed to the hydraulic

test stand.

It should be noted that these instructions are as brief as

possible.

Additional information is included in the descriptive

material in the maintenance section of this manual.

For the location

identifies the operating controls and indicators.

of valves, meters, gauges, switches, etc., refer to Figures 2, 3

and 4.

2-2 PREPARATION FOR USE

(a) Place the Actuator Test Stand conveniently near a 120V,

60 Hz power outlet.

fasteners which retain the top cover

(b) Release the

and the control drawer.

the knurled fasteners.

(d) Open control drawer until the latches, which retain the

drawer at half open position, engage.

(e) Remove the hold down brackets and level the test stand

by means of the leveling screws located at each bottom corner of

the stand.

(f) Check hydraulic fluid level and fill, as required, by

releasing the

fasteners at the front edge of the work area

and raising the perforated work surface plate.

Capacity is

Use MIL-H-5606 Hydraulic Fluid only.

NOTE :

approximately 9 quarts.