 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 GENERAL INFORMATION
INTRODUCTION
1-1
This manual contains general instructions for the operation
and maintenance of the Hydraulic Actuator Test Stand.
The Hydraulic Actuator Test Stand is a "GO" - "NO-GO" test
device.
The Test Stand may be used for testing Military Standard
Hydraulic Actuators of Styles DOD #69-600-1, 69-600-2,69-600-3,
and 69-600-4, and other applicable style numbers listed in Table 2-2.
The tests provided by this stand determine the operational condition
of the actuator hydraulic and electronic components.
TECHNICAL CAPABILITIES
Actuator Tests:
The Test Stand allows the following "GO" - "NO-GO" tests
to be performed on the actuator:
Mechanical Bias
(A)
A check to determine whether the actuator is
properly biased to open -- close with no current in the actuator
or
coils.
(B)
Balanced Coil Current
A check that when balanced current is applied to
the coils equal hydraulic pressure is applied to the piston causing
it to remain stationary.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals