Repackaging for Shipment or Limited Storage

TM 55-4920-430-13

4-67. Repackaging for Shipment or Limited

Storage.

(See fig. 2-1.) The exact procedure for repackaging depends on material available and the conditions

under which the equipment is to be shipped or stored. Adapt the procedure below whenever circum-

s t a n c e s permit.

4-68. Packing.

The information concerning the original packaging (para 2-1) will be helpful.

a. Material Requirements. Obtain 20 square feet of styrofoam cushioning material or equal.

b. Packaging. Cut styrofoam to fit cushion on each side of the test set.

c. Packing. Pack the test set in a cleated plywood box.

4-69. Preparation for Storage.

No special preparations are required for storing the test set. Refer to figure 1-2 to be certain that the test

set is complete before closing the cover and storing the test set. The test set shall be stored in a clean dry

area.

4-70. Preparation for Shipment.

Prepare the test set for shipment as follows:

a. Disconnect and secure cables in cover of the test set.

b. Refer to figure 1-2 to be certain that the test set is complete.

c. Place the cover on the test set. Secure the five latches on the test set. The test set is now ready for

shipment.

4-77/(4-78 blank)