TM 5-6350-275-24&P
3-131 Continued
The keypad starts selecting and controlling each sensor. During the test, the display changes to the following:
WLK SLF ZNE SGL
PIR 1 ST OK
The ST indicates self test. If the test is successful, the ST changes momentarily to SG1 SELF TEST OK to indicate an
alarm tested good.
If the sensor fails the test, the display changes to "Test Failure" momentarily.
At the end of the sequence, if all sensors test OK, the keypad displays a test completed message.
Step 9. Sensor Shunt
With the required access level, you can selectively shunt sensors in the alarm state to secure areas if a sensor fails.
Only alarm indications can be shunted. Sensor tampers must be corrected. Only zone and perimeter alarms can be
shunted. Sensors classed as 24 hour alarm cannot be shunted.
Step 10. Applying Shunt
To apply a shunt to a sensor, log into the keypad to the first menu level by entering your PIC number followed by GO.
In access mode
SEC EXT CMD DIS
In secure mode
ACC EXT CMD DIS
Select F4 (DIS). The LCD shows the second level soft key options: ALM 24H MTC HST. Select f# (MTC) to display the
third level menu:
TST SNT CLR
Select F2 (SNT) to display the fourth level menu:
SNT CLR ZNE PER
Select F1 (SNT) with either F3 (ZNE) or F4 (PER) to list sensors defined in the zone. The display scrolls through the
points. Use F3 (HALT) to stop the display at the sensor to be shunted. F4 (OPER) applies a shunt to the sensor. The
display appears as:
TST SNT CLR
PIR 1 SH OK
The SH indicates a shunted sensor.
After a time-out period, the display returns to the second and the first level menu.
3-243