TM 5-6350-275-24&P
3-17. REPLACE CENTRAL PROCESSING UNIT (CPU) EVENT PRINTER ASSEMBLY.
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
General Safety Instructions:
Screwdriver, Flat tip (Item 6, App B)
Remove all jewelry while working on
Materials/Parts:
equipment.
Event Printer
Equipment Condition:
Serial Interface Card removed (Para. 3-25)
WARNING
Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do
so may result in serious injury or death.
To avoid personal injury, use an adequate number of personnel to lift or move equipment weighing over
50 pounds or oversize equipment. Observe correct lifting techniques. Failure to do so may result in
serious injury or death.
a.
Removal
(1) Press printer power switch (10) to off position.
(2) Remove ac power cord (8) from printer assembly and remove serial interface cable (6) from printer serial
interface card connector (9).
b.
Installation
(1) Install Serial Interface Card.
(2) Connect serial interface cable (6) to printer serial interface card connector (9).
(3) Connect ac power cord (8) to printer assembly.
(4) Press printer power switch (10) to on position.
(5) Insure printer set-up parameters are correct. (ref. Appendix E pg.E-54)
3-18. REPLACE PRINTER SERIAL INTERFACE CABLE. (Figure 3-26).
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
Equipment Condition:
Screwdriver, Flat tip (Item 6, App B)
PMC cabinet doors open
Materials/Parts:
General Safety Instructions:
Serial Interface Cable XC-698-1S
Remove all jewelry while working on
equipment.
a.
Removal
3-89
