Chapter 5. Shipment and Limited Storage and Demolition to Prevent enemy Use

material and seal with pressure-sensi-

20. Preparation for Shipment or Limited Storage

tive tape.

a. Disconnect all test leads from the resolver

(2) Overwrap the packaged equipment

test set filter, and all additional equipment used

tightly in corrugated fiberboard and

in the test procedure.

seal with gummed paper tape.

b. Coil the cables neatly, and tie each coiled

(3) Coil the cable attached to the filter,

cable with cotton twine.

and tie it with twine. Place the filter

in the middle of the coil, wrap the

21. Repackaging for Shipment or LImited Storage

unit in waterproof barrier material,

The exact procedure for repackaging Test

seal with pressure-sensitive tape, and

Set, Resolver AN/ASM-101 depends upon the

place padding around the unit.

materials available and the conditions under

(4) Overwrap the packaged filter tightly

which the equipment is to be shipped or stored.

in corrugated fiberboard and seal with

Whenever possible, adapt the procedures out-

gummed tape.

lined in a and b below. The informtion con-

cerning the original packaging (par. 8) will

(5) Wrap the coiled test and interconnect-

also be helpful.

ing cables together in corrugated fi-

berboard and seal with gummed pa-

a. Materials Required. The materials and the

per tape.

approximate quantities of each required for re-

packaging Test Set Resolver AN/ASM-101 are

(6) Wrap the technical manuals in water-

listed in the chart below. For stock numbers of

proof barrier material, and seal with

materials, refer to SB 38-100.

pressure-sensitive tape.

(7) Place the packaged resolver test set,

filter, and cables in the fiberboard box

and place the packaged technical man-

uals within the box.

(8) Fill all remaining space within the

box with filler material and pads of

fiberboard to prevent all movement

within the box.

(9) Fold down the flaps of the fiberboard

box and seal all seams and closures

with pressure-sensitive tape.

b. Packaging.

(10) Mark the outside of the fiberboard

(1) Pad the front panel of the resolver

box as prescribed in MIL-STD 129B

test set with filler material, and then

a n d pertinent instructions in the

wrap the unit in waterproof barrier

movement directive.