Section Il. INSTALLATION INSTRUCTIONS AND PRELIMINARY ADJUSTMENT OF EQUIPMENT

TM 11-6625-467-12

during shipment. I f the equipment has been

b. Removing Contents. Remove the test set from

damaged, report the damage on SF 364 (Report of

the shipping container as follows:

Discrepancy (ROD)) as prescribed in AR 735-11-2.

WARNING

b. See that the equipment is complete as listed on

Prevent personal injury when applying or

the packing slip. If a packing slip is not available,

removing steel strapping by wearing

check the equipment against the components of end

heavy gloves and protective eye wear. Do

item list (Appx B). Report all discrepancies in ac-

not handle packing cartons by the steel

cordance with TM 38-750. Shortage of a minor

strapping.

assembly or part that does not affect proper func-

(1) Cut and remove the metal bands.

tioning of the equipment should not prevent use of

(2) Use a knife or sharp instrument to cut the

the equipment.

gummed tape that seals the top of the corrugated

c. If the equipment has been used or recon-

carton.

ditioned, see whether it has bn changed by a

(3) Open the top of the corrugated carton and

modification work order (MWO). If the equipment

remove the protective cushioning material from the

has been modified, the MWO number will appear on

top and sides of the equipment; remove the technical

the front panel near the nomenclature plate. If

manuals.

modified, see that any operational instruction

(4) Remove the test set.

changes resulting from the modification have been

entered in the equipment manual. Refer to DA Pam

2-2. Checking Unpacked Equipment

310-7 for MWO'S applicable to the equipment.

a Inspect the equipment for damage incurred

Section Il. INSTALLATION INSTRUCTIONS

AND PRELIMINARY ADJUSTMENT OF EQUIPMENT

2-3. Installation of Fuses

installed in the fuseholders. Table 2-1 shows the

locations and ratings of the fux.

Four fuses are contained in fuseholders on the front

pad of the test set. Be sure the proper fuses are

Table 2-1. Fuse Values and Locations

ditional compensation for low line voltage. When

2-4 Initial Adjustment

(fig. 2-2)

the equipments initially received, the line voltage

from which the equipment will operate should be

The test set as shipped from the factory requires

determined. Subparagraphs a and b below give the

115-volt, 50 to 1000 Hertz, power. However,

procedures for connecting the equipment for the

facilities are included in the equipment to allow

various input voltages.

operation from either 115 volts or 230 volts. Taps on

the primary of the power transformer provide ad-

2-2