 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-6625-3024-14/EE641-AC-MMA-010/E154 SYSEX/TO 33AA50-5-1-1
3. Press STOP switch to stop transport. Verify
Note
that STOP indicator lights and RUN FORWARD
indicator extinguishes.
SELECT 1 through SELECT 4
switches and indicators are grouped
4. Press REWIND.
under MOTION CONTROL but are
address select switches.
3-13.
READ DATA OPTIONS
Three options are available in the Read Data
mode. DATA CONTROL-CONT, READ, BLOCK
3-15.
REWIND
MODE, and BLOCK MODE with REPEAT ON
Enables the transport in REWIND operation.
ERROR can be selected in Read Data Mode. Refer
When REWIND is selected, no errors are detected.
to paragraphs 3-7, 3-10 and 3-11 for operation of
The IN-REWIND status indicator will light. The
these functions.
transport motion cannot be stopped until
Beginning-of-Tape (BOT) is reached. At this time
Data will be played back in the same format as
BOT indicator will light, IN-REWIND indicator
recorded.
will extinguish, and REWIND switch indicator will
extinguish.
After the write data format has been selected
and recorded on tape, the data can be read as
follows:
3-16.
FAST
1. Ensure that Exerciser is in the Standby mode
Enables the transport in FAST tape motion
(see paragraph 3-9).
when combined with RUN FORWARD or RUN
REVERSE switches. The Exerciser will not write
2. Press MOTION CONTROL-RUN FORWARD
data or read errors in the FAST mode. The trans-
switch. Verify that STOP indicator extinguishes
port can be stopped during FAST mode by press-
and RUN FORWARD indicator lights.
ing the STOP switch.
The Exerciser will read data as recorded on tape.
The PARITY ERRORS will count and display de-
3-17.
RUN REVERSE
tected errors. The VRC ERROR and LRC ERROR
indicators will display the type of error detected.
Enables the transport in reverse tape motion.
The Exerciser will not write data or read errors in
3. Press STOP switch to stop motion of trans-
port. Verify that STOP indicator lights and RUN
Reverse mode. The transport can be stopped dur-
FORWARD indicator extinguishes,
ing Reverse mode by pressing the STOP switch.
4. Press REWIND.
3-18.
RUN FORWARD
Enables the transport in forward tape motion.
3-14.
MOTION CONTROL
RUN FORWARD enables only the read circuits.
The transport can be stopped in RUN FORWARD
The MOTION CONTROL switches enable the
mode by pressing the STOP switch.
transport in the commanded direction.
3-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals