|
|
TM 11-6625-2884-30/NAVAIR 16-35TS3615-2
REPLACEMENT OF CONTROL INDICATOR 1A1A1 (Continued)
REMOVAL
a. Disconnect air hose and all connectors from BTS:
CABLE DESIGNATION
JACK NOMENCLATURE AND NUMBER
W1
Monitor J1
W2
Control J2
W3
28V Power J3
W5
CMBD RF J4
W6
115V 60 Hz J5
W7
28 VDC J6
Air Duct
Not designated (located
near top of panel)
Close hinged cover (1) over BTS side connector panel.
b.
C.
Lay BTS down (2) on hinged cover side.
Loosen four screws holding Control Panel Assembly 1A1 to BTS.
d.
CAUTION
Control Panel Assembly 1A1 is wired to the BTS. Be
careful not to pull or twist wires while handling
1A1.
e. Pull Control Panel Assembly 1A1 forward. Rotate 1A1 and set it in
front of BTS (3).
Remove four Phillips head screws and washers (4) from control
f.
indicator gusset (5).
Remove connector (6) from rear of Control Indicator 1A1A1.
g.
On front of 1A1A1 turn two fasteners (7) to left.
h.
Pull 1A1A1 forward and out of control panel assembly.
3-104
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |