 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-6625-2884-30/NAVAIR 16-35TS3615-2
REPLACEMENT
Perform the following steps.
b.
Loosen captive screw (2) and lift enclosure lid for access.
2.
Identify circuit card by part number, and locate its chassis
connector.
3.
Orient cicuit card so its connector polarizing pins match holes at
ends of chassis connector.
4.
Slide circuit card into card guides and push to chassis connector.
5.
Be sure polarizing pins enter matching holes, then seat circuit card
fully in chassis connector.
6.
Pull enclosure lid forward over circuit cards, and fasten with
captive screw (2).
REPLACEMENT OF CONTROL INDICATOR 1A1A1
3-39. To replace Control Indicator 1A1A1, remove the front and rear covers
of the BTS and perform the following steps.
CAUTION
Turning one screw too far or using excessive torque
may crack connector body or strip screw thread.
3-103
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals