Table 3-1. Consumable Materials

TM 55-4920-430-13

Table 3-1. Consumable Materials

MILITARY

ITEM

SPECIFICATION

NOMENCLATURE

NUMBER

P-D-680

Dry Cleaning Solvent

CCC-C46A

Cloth, Cleaning

P-S-624

Soap, Toilet, Liquid and Paste

GGG-C-520

Cloth, Abrasive; Type II, Class I,

220 Grit or Finer

TT-N-95

Naphtha, Aliphatic, Type II

MIL-E-15090

Enamel Light Gray, Semi-Gloss, Type

III, Class 2

MIL-STD-595A

Enamel, Gloss Black, Color No. 17038

MIL-C-22750

Enamel, Flat Black

MIL-P-23377

Epoxy Primer

(a) Touch-up case or cover markings with gloss black enamel. (Item 7, table 3-1.)

b. Panel.

(1) Finish - Touch-up is not recommended.

( 2 ) Markings - For touch-up of lettering use flat black enamel. (Item 8, table 3-1.)

3-5. Replacement of Knobs.

a. Loosen the two recessed socket head screws on the knob.

b. Remove the knob from the shaft.

c. Position the replacement knob on the shaft.

d. Tighten the two screws on the shaft.

3-6. Replacement of Lamps.

a. Unscrew the lens from the lamp holder.

b. Lift out the defective lamp.

Insert the replacement lamp.

d. Position the lens on the lamp holder and hand tighten.

3-7. Cable/Connector Repair.

Refer to TM 55-1500-323-25. Cable wiring diagrams are in fig. 3-1 thru 3-6 of this manual.

3-8. Replacement of AC/DC VOLTMETER Lens Cover.

a. Remove the lens cover by inserting a thin screw driver or knife blade, under the edge of the cover

and apply pressure.

b. Install the lens cover, by placing the lens cover on the AC/DC VOLTMETER, and apply only

enough force to snap the lens cover on the AC/DC VOLTMETER.

3-2