Chapter 1. INTRODUCTION - TM-5-6625-2694-13-P0011

TM5-6625-2694-13&P

CHAPTER 1

INTRODUCTION

Section I. GENERAL

1-1. Scope.

This manual is for use by operator and direct support

personnel for operation and maintenance of the Model 1057 Electrical

Test Set. The Model 1057 Electrical Test Set

(Figure 1-1)

is a 0-33

KW load bank used for presenting dummy loads to engine driven single

phase and

three phase generators.

2 and

Chapters

3 provide

information on operation, preventative maintenance services, and

operator's maintenance of the equipment. Chapter

4 is not applicable

and Chapter 5 details direct support maintenance instructions.

1-2. Maintenance Forms and Records.

Department of the Army forms

and procedures used for equipment maintenance will be those prescribed

by DA Pam 738-750, The Army Maintenance Management System (TAMMS).

1-3.

Reporting Equipment Improvement Recommendations (EIR's). If

your Test Set needs improvement, let us know.

Send us an EIR.

You ,

the user, are the only one who can tell us what you do not like about

your equipment. Let us know why you do not like the design.

Tell us

why a procedure is hard to perform.

Put it on a SF 368 (Quality

Deficiency Report). Mail it to Commander, U.S. Army Troop Support Com-

mand, ATTN: AMSTR-QX, 4300 Goodfellow Blvd., St. Louis, MO 63120-1798.

We'll send you a reply.

1-4.

Destruction

of Army Material

to Prevent

Enemy Use.

(Refer to

TM 750-244-3.)

1-5.

Preparation for Shipment and Storage.

(Refer to TM 750-90-1.)

Change 1

1-1