TM 5-6350-275-24&P
3-68. REPLACE TAMPER SWITCH. (See Figure 3-41).
This task consists of:
a. Remove
b. Install
INITIAL SETUP
Equipment Condition:
General Safety Instructions:
Input power removed
Remove all jewelry while working on equipment.
Enclosure access cover removed
Materials/Parts:
Wear ESD wriststrap while working on equipment
Tamper switch
WARNING
Shut off power source before attempting to disconnect, service, or connect wires
or cables. Failure to do so may result in serious injury or death.
a. Removal
(1) Tag and remove the two slip-on connectors (5) from Tamper Switch (6), by holding and pulling out on
connectors.
(2) Using a flat tip screwdriver, remove the two screws (8) and flat washers (7) holding Tamper Switch (6) to
enclosure.
(3) Remove Tamper Switch (6) from enclosure.
b. Installation
(1) Align Tamper Switch (6) up with enclosure mount (23) and secure with two screws (8) and flat washers (7).
(2) Connect the tagged wires and connectors (5) to Tamper Switch (6).
(3) Reconnect input power.
(4) Replace enclosure cover and secure.
3-151