TM 5-6350-275-24&P
3-37. REPLACE REMOTE AREA DATA COLLECTOR PANEL ASSEMBLY (INTERIOR). (Figure 3-38).
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
General Safety Instructions:
Screwdriver, Flat tip (item 6, App B)
Remove all jewelry while working on
Screwdriver, Flat tip (Item 8, App B)
equipment.
Open End Wrench Set (Item 13, App B)
Wear ESD wriststrap while handling electronic
Equipment Condition:
assemblies.
AC adapter disconnected
Materials/Parts:
Remote Area Data Collector (RADC) Assembly
WARNING
Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do
so may result in serious injury or death.
a. Removal
(1)
Open and remove front access cover from enclosure.
(2)
Remove slip-on terminal strip from TB1 (14) on Stargate PWA (19).
(3)
Tag and remove wires from input side of TB K (11).
(4)
Remove phone line input wiring to DLP2 (10) or fiber optic input cables from fiber optic PWA (4).
(5)
Using a flat tip screwdriver, remove four screws (16) holding panel assembly (17) to enclosure.
(6)
Remove panel assembly (17) from enclosure.
b. Installation
(1)
Place panel assembly (17) inside enclosure.
(2)
Using a flat tip screwdriver, align and secure panel assembly (17) to enclosure with four round head screws
(16).
(3)
Connect phone line input wiring to DLP2 (10) or fiber optic cables to fiber optic PWA (4).
(4)
Connect tagged wires to input side of TB K (11).
(5)
Connect tagged slip-on terminal strip to TB1 on Stargate PWA (19).
(6)
Connect AC adapter (35) to power source.
3-115
