TM 5-6350-275-24&P
3-35. REPLACE RSM 9600 BAUD MODEM. (See Figure 3-37).
This task consists of:
a. Remove
b. Install
INITIAL SETUP:
Tools:
General Safety Instructions:
Screwdriver, Flat tip (Item 6, App B)
Remove all jewelry while working on
Equipment Condition:
equipment.
Input power removed
Materials/Parts:
Wear ESD wriststrap while handling electronic
9600 Baud Modem
assemblies.
WARNING
Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do
so may result in serious injury or death.
a. Removal
(1)
Turn the Modem power switch to off, located on rear of Modem (2).
(2)
Remove audio cable from telset leased line connector on rear of Modem (2).
(3)
Remove the two captive screws holding the RS232 cable to DTE connector on rear of Modem.
b. Installation
(1)
Connect the RS232 cable to DTE connector and secure with two captive screws.
(2)
Connect the audio cable to telset leased line connector.
(3)
Connect the AC power cord to AC power source.
(4)
Turn the Modem (2) power switch to on.
(5)
Set up modem. (Ref. Appendix E, page E-57).
3-113