TM 5-6350-275-24&P
CHAPTER 1
INTRODUCTION
Section I. GENERAL INFORMATION
1-1. SCOPE.
a.
Type of Manual: Unit, Direct Support and General Support Maintenance Manual Including Repair Parts and
Special Tools List.
b.
Equipment Name: Integrated Commercial Intrusion Detection System (ICIDS).
c.
Purpose of Equipment: Detects unauthorized intrusions, and generates alarms upon unauthorized entry into
secured areas by use of various sensors.
1-2. MAINTENANCE FORMS, RECORDS, AND REPORTS. Department of the Army forms and procedures used for
equipment maintenance will be those prescribed by The Army Maintenance Management System, DA PAM 738-750.
1-3. CORROSION PREVENTION AND CONTROL (CPC). Corrosion Prevention and Control (CPC) of Army material is
a continuing concern. It is important that any corrosion problems with this equipment be reported so the problem can be
corrected and improvements can be made to prevent the problem in future items.
a.
While corrosion is typically associated with rusting of metals, it can also include deterioration of other materials.
such as rubber and plastic. Unusual cracking, softening, swelling, or breaking of these materials may be
symptoms of a corrosion problem.
b.
If a corrosion problem is identified, it can be reported using Standard Form 368, Product Quality Deficiency
Report. Use of key words such as "corrosion", "rust", "deterioration", or "cracking" will assure that the information
is, identified as a CPC problem.
c.
This form should be submitted to: Commander, U.S. Army Aviation and Troop Command, ATTN: AMSAT-I-
MDO, 4300 Goodfellow Blvd., St. Louis, MO 63120-1798.
1-4. DESTRUCTION OF ARMY MATERIAL TO PREVENT ENEMY USE. For this unclassified document, destroy by
any method that will prevent disclosure of contents or reconstruction of the document. Refer to TM 750-244-3 for
instructions covering destruction of Army material to prevent enemy use.
1-5. PREPARATION FOR STORAGE OR SHIPMENT. Refer to Chapter 2, Section VII.
Preparation for storage or shipment.
1-6. QUALITY ASSURANCE. Quality Assurance (QA) has been performed on this manual in accordance with MIL-M-
85337A (NAVY) and MIL-M-63038C (TM).
1-1
