TM 5-6350-275-24&P
CHAPTER 2
UNIT MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION INSTRUCTIONS
2-1. LUBRICATION. There are no lubricating procedures associated with the ICIDS equipment. The only lubricating oil
used is for preventive maintenance on the camera support hinge or mounting bracket, if applicable. This lubricating oil is
identified in Appendix D, Item 11, Expendable/Durable Items List.
Section II. REPAIR PARTS; TOOLS; SPECIAL TOOLS;
TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE);
AND SUPPORT EQUIPMENT
2-2. COMMON TOOLS AND EQUIPMENT. Refer to Appendix B, Section III, Tools and Test Equipment Requirements,
for a listing of common tools and equipment.
2-3. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. There are no special tools or equipment required for
unit maintenance of the ICIDS.
2-4. REPAIR PARTS. Refer to Appendix C, Section II, Repair Parts and Special Tools List (RPSTL) for a list of repair
parts covering unit maintenance for this equipment.
Section III. SERVICE UPON RECEIPT OF MATERIAL
2-5. INSPECTION. There are no inspection services performed at the Unit Level.
2-6. SERVICE. Not applicable.
Section IV. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-7. INTRODUCTION. This section describes preventive maintenance checks and services (PMCS) which must be
performed by the unit maintenance personnel to maintain the ICIDS in operational condition. Preventive maintenance
includes cleaning and inspection procedures. Such procedures are performed as outlined by the PMCS Table 2-1 to
detect conditions which might cause the performance of the equipment to deteriorate or cause equipment failure. The
PMCS table has been provided so you can keep your equipment in good operating condition and ready for its primary
mission.
2-8. EQUIPMENT ILLUSTRATIONS. Figure 2-1 is the illustration and routing diagram showing the order in which
checks and services are performed.
2-1
