TM 5-6350-264-14&P-9
NAVELEX EE 181-AA-OMI-100/E121 DZ-204
T.O. 31S9-2FSS9-1-9
f. To install new transformer, cut
m. To remove power transformer, note
transformer wires to proper length and
length and connector location of
install crimp terminals.
Position
transformer wires. Disconnect wires.
transformer on inner enclosure and
Remove mounting screws and washers
install mounting screws and lock
and remove transformer.
washers. Connect wires to terminal
board.
n. To install new transformer, cut
transformer wires to proper length and
g. To remove capacitor, tag and remove
install crimp terminals.
Position
wires. Loosen screw on mounting
transformer on inner enclosure and
bracket and remove capacitor.
install mounting screws and washers.
Connect transformer wires.
h. To install, position new capacitor in
mounting bracket and tighten mounting
o. To remove power switch, slide inner
screw.
Connect wires to capacitor
enclosure part way out of outer
terminals.
enclosure. Remove screws from switch
bracket. Lower switch bracket to gain
i. To remove door tamper switch, remove
access to power switch. Tag wires and
tamper switch support mounting screws.
use a soldering iron of 50 watts
Push switch through outer enclosure.
maximum to unsolder wires. Remove
Tag wires and use a soldering iron of 50
knurled nut and remove power switch.
watts maximum to unsolder wires.
Unscrew switch from switch support and
p. To install, position new power switch
remove switch.
bracket and install knurled nut. Solder
switch wires to switch terminals.
j. To install new door tamper switch,
Position switch bracket on inner
screw switch into switch support. Solder
enclosure and install mounting screws.
wires to switch terminals.
Position
Slide inner enclosure into outer
switch and support on outer enclosure.
enclosure.
Install tamper switch support mounting
screws.
q. To remove battery, disconnect battery
wires from battery. Remove screw and
k. To remove pry-off tamper switch,
washer from battery clamp bracket and
remove mounting screws from tamper
remove battery.
switch bracket. Remove snap on button
cap. Remove hex nut and push switch
r. To install, position new battery and
through switch bracket. Tag wires and
battery clamp bracket. Install screw and
use a soldering iron of 50 watts
washer.
Connect battery wires to
maximum to unsolder wires. Remove
battery.
tamper switch.
s. To remove connector P2/J2, loosen
l. To install new pry-off tamper switch,
solder wires to switch terminals and
collar on connector P2. Turn metal tab
90 degrees and disconnect P2 from J2.
position in switch bracket. Install hex
nut and snap on button cap. Position
Unscrew collar and tag wires. Use a
soldering iron of 50 watts maximum to
switch and switch bracket on inner
enclosure mounting bracket and install
unsolder wires on P2 and J2. Remove
hex nut and remove connector.
mounting screws.