TM 5-6350-264-14&P-2
NAVELEX EE181-AA-OMI-03A/E121 RT1161 M9443
T.O. 31S9-2FSS9-1-2
CHAPTER 1
INTRODUCTION
Section I. General
1-1. SCOPE This manual is for your use in operating
1-4.
DESTRUCTION OF ARMY MATERIEL TO
and maintaining the Ultrasonic Motion Signal
PREVENT ENEMY USE. Instructions for the
Processor, MX-9444/FSS-9(V) and Ultrasonic Motion
destruction of Army materiel to prevent enemy use
Signal Transceiver, RT-1161/FSS-9(V), under normal
are contained in TM 750-244-3.
operating conditions. When these two units are
combined, they form an Ultrasonic Motion Sensor
1-5. QUALITY ASSURANCE/QUALITY CON-
(UMS). The UMS is an integral part of the Joint-
TROL. There are no Quality Assurance/Quality
Services Interior Intrusion Detection System (J-
Control technical manuals applicable to this
SIIDS). For information on other major assemblies of
equipment.
J-SIIDS, refer to the applicable manual listed in
appendix A.
1-6. REPORTING EQUIPMENT IMPROVEMENT
RECOMMENDATIONS (EIR). EIR's will be prepared
1-2. MAINTENANCE FORMS AND RECORDS.
on Standard Form 368, Quality Deficiency Report.
Equipment maintenance forms and procedures for
Instructions for preparing EIR's are provided in DA
their use are contained in DA Pamphlet 738-750, The
Pamphlet 738-750. EIR's should be mailed directly to
Army Maintenance Management System (TAMMS).
Commander, U.S. Army Troop Support Command,
ATTN: AMSTR-QX, 4300 Goodfellow Blvd., St. Louis,
1-3. ADMINISTRATIVE STORAGE. Instructions
Missouri 63120-1798. A reply will be furnished directly
for administrative storage are contained in
to you.
TM 740-90-1.
1-7.EQUIPMENT SERVICEABILITY CRITERIA
(ESC). This equipment is not covered by an ESC.
Section II. DESCRIPTION AND DATA
tions, and all electronic components. The
1-8. DESCRIPTION.
chassis has a removable cover and access
holes where interconnecting wiring is brought
a. The Ultrasonic Motion Sensor (UMS) consists
in through conduit.
of a Processor and a Transceiver. The Sensor
is one of a series of components used to
detect an intrusion into a secure area. It
board mounted inside a steel chassis. Mounted
receives operating power from and sends
on the PC board are the range control, TAS,
alarm signals to the J-SIIDS Control Unit.
terminal strip for wire connections, and all
electronic components. Transmit and receive
transducers are supported by mounts inside
circuit board (PC board) mounted inside a steel
each end of the chassis. The chassis has a
chassis. Mounted on the PC board are the
removable cover and access holes where
tamper alarm switch (TAS), terminal strips for
interconnecting wiring is brought in through
wire connec-
conduit.
Change 1 1-1