TM 5-6350-264-14&P-10
NAVELEX EE 181-AA-OMI-11A/E121 C-9412
T.O. 31S9-2FSS9-1-10
CHAPTER 1
INTRODUCTION
Section I. GENERAL
1-1. SCOPE. This manual is for your use in operating
1-4.
DESTRUCTION OF ARMY MATERIEL TO
and maintaining the Alarm Set, Control Unit Model C-
PREVENT ENEMY USE. Instructions for the destruction
9412/FSS-9(V), under normal operating conditions. The
of Army materiel to prevent enemy use are contained in
Control Unit (CU) is an integral part of the Joint-Services
TM 750-244-3.
Interior Intrusion Detection System (J-SIIDS).
For
information on other major assemblies of J-SIIDS, refer
1-5.
QUALITY ASSURANCE/QUALITY CONTROL.
to the applicable manual listed in appendix A..
There are no Quality Assurance/Quality Control technical
manuals applicable to this equipment.
1-2.
MAINTENANCE FORMS AND RECORDS.
Equipment maintenance forms and procedures for their
1-6.
REPORTING EQUIPMENT IMPROVEMENT
use are contained in DA PAM 738-750, The Army
RECOMMENDATIONS (EIR). EIR's will be prepared on
Maintenance Management System (TAMMS).
standard Form 368, Quality Deficiency Report.
Instructions for preparing EIR's are provided in DA PAM
1-3. ADMINISTRATIVE STORAGE. Instructions for
738-750. EIR's should be mailed directly to Commander,
administrative storage are contained in TM 740-90-1.
U. S. Army Troop Support Comamnd, ATTN: AMSTR-
QX, 4300 Goodfellow Blvd. , St. Louis, Missouri 63120-
1798. A reply will be furnished directly to you.
Section II. DESCRIPTION AND DATA
top of the power supply (fig. 1-3, view b); one located on
the bottom of the status processor (fig. 1-3, view c).
consists of a steel enclosure, a power supply, a battery
for emergency operation, a status processor, associated
b. Equipment Characteristics.
controls, and input/output terminal boards.
The
enclosure also contains mounting provisions for the Data
Weight (Control Unit less battery and
Transmitter T-1257/FSS-9(V) (not part of the Control
Data Transmitter .............. 38 pounds (17.24 kg)
Unit). The Control Unit is the central control element of
J-SIIDS. A tamper alarm switch (TAS) automatically
Dimensions (overall)
initiates an alarm when the access door is opened.
Height............................... 22.500 inches (57.5 cm)
1-8. TABULATED DATA.
Width................................ 8.250 inches (21.0 cm)
a. Identification Data. There are three identification
plates on the Control Unit as follows: One located inside
Depth ............................... 14.625 inches (37.0 cm)
the access door (fig. 1-3, view a); one located on
Change 1 1-1