|
|
TM 11-7010-201-40-5/ET821-AA-MMI-050/E154 MTS/TO 31S5-2TSQ73-2-5
Section II. OPERATION
3-3. Introduction. This section provides operating procedures for the MTS test aid. Procedures for operation of the
MTS test aid consist of troubleshooting the MTS and troubleshooting wiring.
3-4. Troubleshooting MTS. The MTS test aid may be used during MTS fault isolation as follows:
a. Connect MTS test aid to MTS as described in paragraph 2-4.
b. Set BCP switch down.
c.
Set SS switch down.
d. Perform MTS fault isolation procedure (TM 11-7010-201-12) using table 3-2 for correlating MTS J7 connector pin
numbers to their respective MTS test aid lamps.
3-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |