|
|
TM 11-7010-201-40-1/ET821-AA-MMI-010/E154 MTS/TO 31S5-2TSQ73-2-1
Table 3-1. Connector List Column Explanations - Continued
Column heading
Explanation
G-This connection does not go direct to TO connector but intersects
wire going to TO connector
I -Junction point for multiple laminate board, i.e., printed circuit card
connections
J -Designates bus reference point
SIGNAL
Alphanumeric signal name (mnemonic where feasible) which
differentiates one specific function from another
SEQ. NO.
Not used by maintenance personnel
EQUATION
Symbolic name (significant where feasible) which identifies logic
equation driven by signal
TERM
Designates whether signal is output (00) or input (01)
FACTOR
Designates order in which signal is listed in FACTOR column of logic
list
CKT OR CHIP TYPE
Indicates type of card in slot
GROUP
Designates specific element of IC chip
LOAD OR POWER PLANE
Not used by maintenance personnel
TEST POINTS
Letter or numerical which indicates AND (input signal) test point if
located on left side of column or OR (output signal) test point if located
on right side
SIGNAL DESCRIPTION
Abbreviated description or name of signal or voltage
ECO NO.
Letter-number combination to show ECO level of spe-
cific wire list
3-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |