|
|
TM 11-7010-201-40-1/ET821-AA-MMI-010/E154 MTS/TO 31S5-2TSQ73-2-1
Table 3-1. Connector List Column Explanations
Column heading
Explanation
RECORD NUMBER
Not used by maintenance personnel
FROM
Originating end of wire
PREFIX
When used, alphanumeric indicating when wire terminates in two
assemblies
CONNECTOR
Any type of terminating point, plug, receptacle
PIN
Exact originating point of respective connector
SH. FIG.
When used, references illustration (figure 3-4) showing how shielded
wire or coax is to be terminated. Number in these fields indicates level
of automatic wire wrapping
TO
Terminating end of wire
PREFIX
Same as FROM prefix
CONNECTOR
Same as FROM connector
PIN
Same as FROM pin
SH.FIG.
Same as FROM sh. fig.
WIRE
MULTIGROUP
Associates wire of group such as twisted wire or shielded wire. Jacket,
pigtails, and center conductor are shown as common group
CODE
Three-digit code for wire type and gage or bus bar
COLOR
Color according to standard RETMA color code: base color, stripe 1,
and stripe 2. If single number used, wire is solid color; if two numbers,
wire has one stripe; if three numbers, two stripes
IDENT
Number stamped on wire or sleeving to differentiate it from another.
Not used in all wiring
SPC. INST. MISC
Code which indicates that wire must be given special attention as
follows:
A-Direct routing with no service loops or harnessing
F-Refer to Signal Description column for this line
3-5
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |