TM 11-7010-201-12/ET821-AA-OMl-010/E154 MTS/TO 31S5-2TSQ73-1
C O M P O N E N T S OF END ITEM AND BASIC ISSUE ITEMS LISTS
Section I. INTRODUCTION
C-3. EXPLANATION OF COLUMNS.
This appendix lists integral components of and basic
a. Illustration. This column is divided as follows:
issue items for the TS-3317( )/TSQ-73 to help you
inventory items required for safe and efficient
(1) Figure Number. Indicates figure number of
the illustration on which the item is shown.
(2) Item Number. The number used to identify
item called out in the illustration.
b. National Stock Number. Indicates the National
stock number assigned to the item and which will be
used for requisitioning.
c. Part Number. Indicates the primary number
used by the manufacturer, which controls the design
This Components of End Item List is divided into the
and characteristics of the item by means of its
engineering drawings, specifications, standards, and
a. Section Il. Integral Components of the End
inspection requirements to identify an item or range
Item. These items, when assembled, comprise the
TS-3317( )/TSQ-73 and must accompany it
d. Description. Indicates the Federal item name
whenever it is transferred or turned in. The
and, if required, a minimum description to identify the
illustrations will help you identify these items.
b. Section Ill. Basic Issue Items. These are the
e. Location. The physical location of each item
minimum essential items required to place the
listed is given in this column. The lists are designed
TS-3317( )/TSQ-73 in operation, to operate it, and to
to inventory all items in one area of the major item
perform emergency repair. Although shipped
before moving on to an adjacent area.
separately packed, they must accompany the
f. Quantity Required (Qty Reqd). This column
TS-3317( )/TSQ-73 during operation and whenever it
lists the quantity of each item required for a complete
is transferred between accountable officers. The
illustrations will assist you with hard-to-identify items.
This manual is your authority to requisition
g. Quantity. This column is left blank for use
replacement BII, based on TOE/MTOE authorization
during an inventory. Under the Rcv'd column, list the
of the end item.
quantity you actually receive on your major item. The
Date columns are for your use when you inventory
the major item at a later date, such as for shipment
to another site.