Chapter 2. INSTALLATION AND OPERATING INSTRUCTIONS

TM 11-6625-667-12/NAVAIR 16-30APM-123-1/TO 33A1-3-367-1

CHAPTER 2

INSTALLATION AND OPERATING INSTRUCTIONS

Section I. SERVICE UPON RECEIPT OF EQUIPMENT

2-1. Unpacking

b. See that the equipment is complete as listed

on the packing slip. If a packing slip is not avail-

a. Packaging Data. When packed for ship-

able, check the equipment against the list of

ment, the test set is placed in a corrugated car-

components in paragraph 17. Report all dis-

ton. A typical shipping carton and its contents

crepancies in accordance with paragraph 3-lc.

are shown in figure 21. The corrugated carton

Shortage of a minor assembly or part that does

is 13 1/2 inches high, 22 1/2 inches deep, and 24

not affect proper functioning of the equipment

inches wide; the volume is 6.7 cubic feet. The

should not prevent use of the equipment.

gross weight of the carton and its contents is

approximately 55 pounds.

c. If the equipment has been used or recondi-

tioned, see whether it has been changed by a

b. Removing Contents

modification work order (MWO). If the equip-

(1) Place the outer container in a location

ment has been modified, the MWO number will

that provides vertical clearance of at least twice

appear on the front panel near the nomenclature

the container height. Keep the container in an

plate. If modified, see that any operational instruc-

upright position, and open the top of the con-

tion changes resulting from the modification have

tainer.

been entered in the equipment manual.

(2) Remove the contents from the outer con-

NOTE

tainer, and then remove the inner container from

the screen foil bag. Open the inner container.

Current MWO'S applicable to the equip-

(3) Remove the top layer cushioning and all

ment are listed in DA Pam 3107.

side layers of cushioning from the inner con-

tainer.

2-3. installation of Fuses

(4) Lift the test set from the inner con-

(fig. 2-2)

tainer and remove the paper wrapping.

The test set is shipped with fuses installed. Be

2-2. Checking Unpacked Equipment

sure the proper fuses are inserted in the fuse

holders on the front panel of the test set. The

a. Inspect the equipment for damage incurred

following chart shows the location and ratings

during shipment. If the equipment has been dam-

of the fuses:

aged, refer to paragraph l-3b for instructions.

Fuses

Reference Symbol

Amps

Volts

Circuit

A1F1 and A1F3

115

Ac input

A1F2 and A1F4

Dc input

2-1