CHAPTER 4. SHIPMENT AND LIMITED STORAGE

TM 11-6625-409-12

CHAPTER 4

SHIPMENT AND LIMITED STORAGE

45(*). For stock numbers of materials, consult SB 38-

4-1.

Disassembly of Equipment

100.

a. Disconnect all test cable assemblies and close

the covers on the test cable receptacles.

b. Turn the METER SELECTOR switch to OFF.

Material

Quantity

c. Store the components of the OA-2494/ARM-45,

test cables, running spares, and technical manuals in the

Waterproof paper ...............................

25 sq ft

storage compartment inside the MX-3736/ARM-45.

Waterproof tape .................................

25 ft

NOTE

Corrugated cardboard ........................

50 sq ft

To facilitate repacking of the test cables in the

Corrugated filler..................................

50 sq ft

storage compartment, the OA-2494/ARM-45

Gummed tape ....................................

25 ft

components should be packed first.

b. Packaging.

d. Close and fasten the case cover.

(1) Use the corrugated cardboard to form an

inner carton large enough (13 by 13 by 20 inches) to hold

4-2. Repackaging for Shipment or Limited

the unit.

Storage

(2) Place a 11/2-inch thick corrugated filler pad

The exact procedure for repackaging depends on the

in the bottom of the carton. Carefully place the test set in

material available and the conditions under ;which the

the carton; fill the voids on each side and the top with

equipment is to be shipped or stored. Adapt the

corrugated filler pads.

procedures outlined below whenever circumstances

(3) Close the carton and seal it with gummed

permit. The information concerning the original

tape.

packaging (para 2-1) will also be helpful.

(4) Place the sealed inner carton inside the

a. Material Requirements The following materials,

waterproof barrier paper and place in the outer carton.

are required for packaging Test Set, Radio AN/ARM-

Seal the waterproof barrier paper and then seal the outer

carton with waterproof tape.

4-1