 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-6625-3056-12
4-10.
KNOB REPLACEMENT
The knobs for the OPERATION and DISPLAY SELECT controls are the same and both are replaceable at
Organizational level.
Tools
3/64 in. Allen wrench.
Required
1.
Removal
Note position at which knob is set.
Use 3/64 in. Allen wrench to loosen the two set screws in the knob.
Pull knob out to remove.
2.
Replacement
Use 3/64 in. Allen wrench to remove the two set screws from the new knob.
Apply a drop of primer (NSN 8030-00-963-0930) to each set screw.
Apply a drop of sealing compound (NSN 8030-00-081-2328) to each set screw.
Use 3/64 in. Allen wrench to reinstall the two set screws in the knob.
Install new knob on shaft in same position as knob that was removed.
Use 3/64 in. Allen wrench to tighten the two set screws that secure knob to shaft.
4-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals