|
|
TM 11-6625-3024-14/EE641-AC-MMA-010/E154 SYSEX/TO 33AA50-5-1-1
6. Remove 6 attaching screws, lock washers
9. Replace the dust cover assembly using 6
and flat washers, to remove the Mother Board
attaching screws along the front edge of the hinge
cover (2).
bracket.
7. Remove connector J7 (3) from Mother
10. Replace Power Supply Assembly, following
Board.
the procedures in paragraph 5-16, Power Supply
Replacement.
8. Remove 2 screws from connectors J9, J11,
J12, and J13 (4) and disconnect from connector
5-23. FUSE REMOVAL AND
panel assembly. Remove cable clamp (5) screw,
REPLACEMENT
lock washer, and flat washer.
1. Fuses 1A2F1 and 1A2F2. To remove and
9. Remove 7 attaching screws to remove the
replace the +28 volt transport power fuse 1A2F1
connector assembly rear bracket (6).
(5 amp SLO-BLOW) and the 28 volt Exerciser
lamps fuse 1A2F2 (3 amp SLO-BLOW), open the
10. Remove 6 attaching screws along top side
bottom access door located under the cabinet.
of connector panel assembly front bracket (7).
(See Figure FO-15.)
(See Figure FO-16 for attaching hardware loca-
tion.)
2. Fuses 1A1A3F1, 1A1A2F1 and 1A1A2F2.
To remove and replace the main fuse 1A1A3F1
11. The connector panel assembly can now be
(5 amp SLO-BLOW), the +5 Vdc #1 fuse
removed.
1A1A2F1 (4 amp SLO-BLOW) and the + 5 Vdc
#2 fuse 1A1A2F2 (4 amp SLO-BLOW), open the
5-22. CONNECTOR PANEL ASSEMBLY
top access door located on the top of the cabinet.
REPLACEMENT
(See Figure FO-15.)
1. Install the connector panel assembly using
5-24. SCHEMATIC NOTES
6 attaching screws along the top side of the con-
nector panel assembly front bracket (7). (See Fig-
1. All resistors on schematic diagrams identi-
fied with a "U" reference designator are part of a
dual-in-line resistor pack.
2. Install the rear bracket (6) using 7 attaching
2. Assembly unit or subassembly unit prefix is
screws.
not shown on reference designators, i.e., R1 =
1A1A2R1.
3. Install connectors J9, J11, J12, and J13 us-
ing 2 screws (4). Install cable clamp using one
3. Input and output signal destinations are
screw (5).
shown at the connector as circuit card number and
connector pin number,
4. Install connector J7 (3) on Mother Board,
5. Install Mother Board cover (2) using 6 at-
taching screws.
6. Install connector assembly cover (1) using
2 attaching screws.
7. Slide the top and bottom card frame paneIs
into place. The panels slide into the side panels
from the rear of the frame assembly. (See Figure
8. Install 3 attaching screws on the back of each
panel.
5-18
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |