Fuse Holder

TM 11-6625-3023-14/ET904-AA-MMA-010/E154 TS3684/TO 33A1-12-1173-1

(2) Install and solder wires as tagged.

(3) Replace circuit board assembly as described in paragraph 6-11b.

(4) Replace panel assembly as described in paragraph 6-8b.

6-13. Fuse Holder. The fuse holder may be removed and replaced by performing the following procedures.

a. Removal. Perform the following procedure to remove the fuse holder from the panel assembly:

(1) Remove panel assembly as described in paragraph 6-8a.

(2) Tag aid unsolder the wires on the fuse holder.

(3) Remove the nut securing the fuse holder to panel assembly and remove holder.

b. Replacement. Perform the following procedure to replace fuse holder on the panel assembly:

(1) Insert fuse holder in the panel assembly and secure with nut.

(2) Install and solder wires as tagged.

(3) Replace panel assembly as described in paragraph 6-8b.

6-14. Resistors. The resistors (R2 and R3) may be removed and replaced by performing the following procedures.

a. Removal. Perform the following procedure to remove the resistors from the panel assembly:

(1) Remove panel assembly described in paragraph 6-8a.

(2) Remove circuit board as described in paragraph 6-11a.

(3) Tag and unsolder the wires on the resistor(s).

(4) Remove the two nuts, lockwasher screws and spacers (two spacers separate R2 and R3) securing the resistor to

the panel assembly and remove resistor(s).

b. Replacement. Perform the following procedure to replace either resistor:

(1) Install resistor(s) on the front panel and secure with two screws, nuts, lockwasher and spacers.

(2) Solder wires as tagged.

6-22