|
|
c. Control Panel Assembly Power Supply 1A1PS3 (+1O Vdc). Remove Control
Panel Assemblv 1A1 from the BTS in accordance with paragraph 3-32B and
perform the following:
Place the control panel in an upside down position on the test
(1)
bench.
Remove caution plate (1) - four pan head screws, lockwashers and
(2)
flat washers.
Tag and unsolder the 115 Vac input wires (2) and the two output
(3)
wires (3) from Power Supply PS3.
Remove pan head screw and lockwasher (4) securing PS3 to power
(4)
supply bracket.
Remove pan head screw, lockwasher and flat washer (5) securing the
(5)
hold down bracket between PS1 and PS3.
Lower and remove PS3 (7) with the hold down bracket and post (6).
(6)
(1) Pos tion replacement +10 Vdc Power Supply 1A1PS3 (7) and bracket
and post (6) on control panel.
(2) Fas en PS3 to power supply bracket, using pan head screw and
lockwasher (4).
(3) Fasten hold down bracket and post (6) to power supply bracket,
using pan head screw, lockwasher and flat washer (5).
(4) Solder 115 Vac input wires (2) and two output wires (3) to Power
Supply PS3, observing dc polarity.
(5) Install caution plate (1) with four pan head screws, lockwashers
and flat washers.
(6) Replace control panel in BTS according to paragraph 3-32d.
3-90
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |