ASSEMBLY, REMOVAL NAD REPLACEMENT

TM 11-6625-2884-30/NAVAIR 16-35TS3615-2

ASSEMBLY

REMOVAL

AND

REPLACEMENT

3-32. The procedure for removal of Status Panel Assembly 1A2, or the two RF

Modulation Assemblies 1A3 or 1A4 is the same. To remove any one of the three

assemblies or all of them, perform the following:

Removal of 1A2, 1A3 or 1A4 Panel Assemblies.

WARNING

Exercise the utmost care during

assembly removal as the RF Modula-

tion Assembly weighs 44 pounds.

CAUTION

When connecting or disconnecting jackscrew connectors:

Turn one screw one turn.

Turn other screw one turn.

Repeat alternate turning of screws.

Do not use excessive torque.

Turning one screw too far or using excessive torque may

crack connector body or strip screw thread!

Be sure to disconnect semi-rigid coax cables from rear of

assembly before removing it. Pulling assembly with cable

attached may damage cable.

Retain nuts and washers when removing grounding straps.

Do not let loose nuts or washers fall into BTS. Loose

hardware can cause a short circuit.

3-74