Replacement of 1A2, 1A3 or 1A4 Panel Assemblies

TM 11-6625-2884-30/NAVAlR 16-35TS3615-2

ASSEMBLY

REMOVAL

AND

REPLACEMENT

(Continued)

Replacement of 1A2, 1A3 or 1A4 Panel Assemblies. The procedure for

replacement of Status Panel Assembly 1A2 , or the two RF Modulation

Assemblies 1A3 or 1A4 is the same. To replace any of the three

assemblies, perform the following:

WARNING

Exercise the utmost care during assembly

replacement as the RF modulation assem-

bly weighs 44 pounds.

CAUTION

Pulling assemblies forward without

disconnecting cables may damage

cables.

NOTE

Two guides on the back of the case frame

mate with two holes at the rear of the

assembly for the purposes of assembly

alinement and stability.

( 1 ) Firmly grasp the two handles of the assembly to be replaced and gently

push the assembly into the case. Continue slowly until the assembly

is almost in its closure at which time carefully and slowly push it

fully in, engaging the guide pins at the rear of the assembly.

(2) Secure panel assembly to BTS case frame with four captive screws.

(3) Connect all cables and grounding straps to front and rear panels of

assembly being replaced.

3-76