 |
|||
|
|
|||
|
Page Title:
TABLE 1-1. CONTROL PANEL ASSEMBLY (CONTROL INDICATOR 1A1A1) CONTROLS AND INDICATORS |
|
||
| ||||||||||
|
|
 TM 11-6625-2884-30/NAVAIR 16-35TS3615-2
CONTROLS AND INDICATORS
FUNCTION
DEVICE
REFERENCE
Controls application of ac power
1
POWER 115 VAC 60 Hz
to BTS. Provides overcurrent
10 circuit breaker
protection to BTS.
1A1CB2
Controls application of dc power
POWER 28V DC circuit
2
to unit under test (UUT). Pro-
breaker 1A1CB1
vides overcurrent protection to
UUT.
Controls status of LRU-1.
3
CONTROL INDICATOR
OPR/STBY/OFF toggle
3-1
switch 1A1A1S1
Applies high voltage to travel-
OPR
ing wave tube (TWT) after 3 min-
ute warm-up delay, (turns TWT on).
Applies dc power to LRU-1, but
STBY
inhibits LRU-1 TWT control.
Removes all dc power from LRU-1.
OFF
When lit, indicates LRU-1 is in
ON indicator (green)
3-2
STBY or OPR mode.
1A1A1DS1
When lit, indicates LRU-1 is in
3-3
STBY indicator (amber)
standby mode.
1A1A1DS2
When lit, indicates LRU-1 is in
3-4
OPR indicator (green)
operate mode.
1A1A1DS3
When pressed, initiates built-in-
4
JAM/TEST/GO/NO-GO
test equipment (BITE) in LRU-1
1A1S4/D11
under test.
JAM (green)
Lights when LRU-1 under test has
acquired a simulated threat and
has activated ECM.
TEST (yellow)
Lights when BITE in LRU-1 under
test has been initiated.
GO (green)
Lights when LRU-1 under test is
operating correctly.
NO-GO (yellow)
Lights when a fault is detected
LRU-1 under test.
1-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals