Section I. INTRODUCTION - TM-11-6625-2884-20P0005

SECTION I

INTRODUCTION

1. Scope

Definition

Code

This manual lists spares and repair parts; special tools;

PA -Item procured and stocked for anticipated or

special test, measurement, and diagnostic equipment

known usage.

(TMDE), and other special support equipment required

XC Installation drawing, diagram, instruction sheet,

for performance of aviation intermediate maintenance

field service drawing, that is identified by

(AVUM) of the TS-3615/ALQ-136(V). It authorizes the

manufacturer's part number,

requisitioning and issue of spares and repair parts as

indicated by the source and maintenance codes.

NOTE

2. General

Cannibalization or salvage may be used as a

source of supply for any. items source coded

This Repair Parts and Special Tools List is divided into

above except those coded XA and aircraft

the following sections:

support items as restricted by AR 750-1.

a. Section //. Repair Parts List. A list of spares and

(2) Maintenance code. Maintenance codes areas-

repair parts authorized for use in the performance of

signed to indicate the levels of maintenance authorized

maintenance. The list also includes parts which must be

to USE and REPAIR support items. The maintenance

removed for replacement of the authorized parts. Parts

codes are entered in the third and fourth positions of the

lists are composed of functional groups in numeric

Uniform SMR Code format as follows:

sequence, with the parts in each group listed in figure

(a) The maintenance code entered in the third

and item number sequence.

position will indicate the lowest maintenance level

b. Section ///. Special Took List. Not applicable.

authorized to remove, replace, and use the support item.

c. Section IV. National Stock Number and Part Number

The maintenance code entered in the third position will

Index. A list, in National item identification number

indicate one of the following levels of maintenance:

(NIIN) sequence, of all National stock numbers (NSN)

appearing in the listings, followed by a list, in alpha-

code

Application/Explanation

numeric sequence, of all part numbers appearing in the

O Support item is removed, replaced, used at the

listings. National stock numbers and part numbers are

aviation unit maintenance level.

cross-referenced to each illustration figure and item

number appearance.

(b) The maintenance code entered in the fourth

position indicates whether the item is to be repaired and

3. Explanation of Columns

identifies the lowest maintenance level with the capabil-

a. Illustration. This column is divided as follows:

ity to perform complete repair (i.e., all authorized

(1) Figure number. Indicates the figure number of

maintenance functions). This position will contain one of

the illustration on which the item is shown.

the following maintenance codes:

(2) Item number. The number used to identify item

called out in the illustration.

code

Application/Explanation

b. Source, Maintenance, and Recoverability (SMR)

Z Nonreparable. No repair is authorized.

Codes.

(1) Source code. Source codes indicate the manner

(3) Recoverability code. Recoverability codes are

of acquiring support items for maintenance, repair, or

assigned to support items to indicate the disposition

overhaul of end items. Source codes are entered in the

action on unserviceable items. The recoverability code

first and second positions of the Uniform SMR Code

is entered in the fifth position of the Uniform SMR Code

format as follows: