SECTION I. INTRODUCTION - TM-11-6625-1644-24P0003

TM 11-6625-1644-24P

SECTION I

INTRODUCTION

NOTE

1. Scope

may be used as a

Cannibalization or

source of supply for any items source coded

above except those coded XA, XD, and air-

craft support items as restricted by AR

nance codes are

2. General

of maintenance

AIR support items. The

pecial Tools List is divided into

maintenance codes are entered in the third and fourth

positions of the Uniform SMR Code format as fallows:

(a) The maintenance code entered in the third

position will indicate the lowest maintenance level

The list also includes parts which must be removed for

authorized to remove, replace, and use the support item.

of the authorized parts. Parts lists are

The maintenance code entered in the third position

functional groups in ascending numerical

will indicate one of the following levels of main-

th the parts in each group listed in figure

tenance:

b. Section III. Special Tools List. Not applicable.

Code

Application/Explanation

c. Section IV. National Stock Number and Part

O- Support item is removed, replaced, used at the

Number Index. A list, in ascending National Item

organizational level.

identification number (NIIN, last 9 digits) sequence, of

H-Support item is removed, replaced, used at the

all National stock numbers appearing in the listings,

general support level.

fallowed by a list, in alphameric sequence, of all part

(b) The maintenance code entered in the fourth

numbers appearing in the listings. National stock

position indicates whether the item is to be repaired

number and part numbers are cross-referenced to each

and identifies the lowest maintenance level with the

illustration figure and item number appearance.

capability to perform complete repair (i.e., all

3. Explanation of Columns

authorized maintenance functions). This position will

tion of columns

contain one of the following maintenance codes:

found in the tabular listings:

Application/Explanation

code

a. Illustration. This column is divided as follows:

H-The lowest maintenance level capable of complete

(1) Figure number. Indicates the figure number of

repair of the support item is the general support

the illustration in which the item is shown.

level.

(2) Item number. The number used to identify

Z- Nonreparable. No repair is authorized.

each item called out in the illustration.

(3) Recoverability code. Recoverability codes are

intenance, and Recoverability Codes

assigned to support items to indicate the disposition

action on unserviceable items. The recoverability

urce codes are assigned to

is entered in the fifth position of the Uniform

Code format as follows:

Recoverability

Definition

codes

Z- Nonreparable item. When unserviceable, condemn

and dispose at the level indicated in position 3.

H-Reparable item. When uneconomically reparable,

condemn and dispose at the general support

level.

d. Part Number. Indicates the primary number u

by the manufacturer (individual, company,