 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-5895-1097-40
WARNING
WARNING
120 volts AC is present at power
Ensure test set is disconnected from
supply
connections
inside
power source before attempting
equipment. Ensure test set is
disassembly. DEATH ON CONTACT
disconnected from power supply
or serious injury may result if safety
source before attempting repairs.
precautions are not observed.
DEATH ON CONTACT or serious
CAUTION
injury may result if safety precuations
Always read over and be sure you
are not observed.
understand the instructions before
attemping disassembly. Use the
CAUTION
illustrations to locate parts and
Use a penciltype soldering iron with a
subassemblies of the unit to be
25watt maximum rating. Too much
disassembled. Careful removal of
heat from the iron will damage the
parts is important to avoid damage to
printed wiring of circuit cards. Use
the equipment.
only enough heat to quickly remove
or
replace
components.
This
To disassemble the test set, refer to figure 3-7 and
equipment is also transistorized. If
proceed as follows:
the iron must be used with ac, use an
a. Ensure POWER switch is in OFF position and ac
isolating transformer between the
power cord is disconnected from power source.
iron and the line. Do NOT use a
b. Remove four screws, lockwashers and washers
soldering gun near the transistorized
(1) from panel assembly (2).
assemblies; damaging voltage may
c. Carefully remove panel assembly (2) from case
be induced in the circuit components.
assembly (3).
NOTE
For additional soldering techniques
refer to TB SIG 222.
3-15. Disassembly
3-17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals