| |
TM1-6625-736-13&P
CHAPTER 4
AVIATION INTERMEDIATE MAINTENANCE (AVIM) INSTRUCTIONS
4-1 GENERAL
4-1
This chapter contains maintenance procedures that are the responsibility of the Aviation Intermediate Maintenance
Technician as authorized by the Maintenance Allocation Chart (MAC) and Source Maintenance and Recoverability
(SMR) coded items in the Repair Parts and Special Tools Lists (RPSTL). The maintenance procedures in this chapter
are prepared in the form of summary and detailed procedures.
4-2 MAINTENANCE OPERATIONS
4-2
These instructions provide the proper technique and detailed procedures required to perform the maintenance
operations. Each maintenance operation provides step-by-step instructions in the order in which the work is most
logically accomplished. Any unusual or critical steps are covered in detail.
SECTION I-REPAIR PARTS, SPECIAL TOOLS, AND SUPPORT EQUIPMENT
4-3 TOOLS AND TEST EQUIPMENT LIST
4-3
Tools and test equipment required for maintenance of the Electronic Test Set are identified in Appendix B.
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
4-4 SPECIAL TOOLS AND SUPPORT EQUIPMENT
4-4
Refer to TB 9-6625-2310-35 for special tools and support equipment.
4-5 REPAIR PARTS
4-5
Repair parts are listed in the RPSTL, Appendix C of this manual.
SECTION II-SERVICE UPON RECEIPT
4-6 GENERAL
4-6
a.
Visually check exterior surfaces of the Electronic Test Set for apparent damage. Check exterior connectors for
damage. Check Top Plate Assembly (C-1-1) for broken switches, missing or broken collar link, missing or
damaged selector knob and broken or damaged lens.
4-1
|