| |
TM1 -6625-736-13&P
(5)
ACC SIGNAL SELECT
Provides a calibrated attenuation of the accelerometer signal. This function checks the Automatic Gain
Control (AGC) of the Electronic Test Set. In EXT position the external accelerometer BNC connector is
selected. This allows the user to route a signal from a second source (such as a synthesizer) to the
accelerometer interface. When using EXT mode be aware that the 54 mV/g accelerometers require about
a 5V offset on the signal to meet bias requirements.
SECTION II OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-4 BEFORE YOU OPERATE
2-4
Always keep in mind CAUTIONs and WARNINGs. Handle the test set like you would any other delicate piece of
electronic equipment. Follow instructions and procedures for proper operation.
2-5 PERFORMANCE CHECKS
2-5
Ensure the Electronic Test Set has a current calibration tag.
SECTION III OPERATION UNDER NORMAL CONDITIONS
2-6 GENERAL PROCEDURES
2-6
This section includes unpacking instructions, installation instructions and operating procedures.
2-7 UNPACKING
2-7
The Electronic Test Set is a self-contained unit.
2-8 INSTALLATION
2-8
No installation is required for the Electronic Test Set.
SECTION IVOPERATION UNDER UNUSUAL CONDITIONS
2-9 UNUSUAL CONDITIONS
2-9
There are no requirements for unusual operating conditions.
2-10 EXTREME ENVIRONMENTAL MAINTENANCE
2-10
There are no requirements for extreme environmental maintenance for the Electronic Test Set.
2-5
|