SWITCH S24 REPLACEMENT.

TM 1-6625-735-14

5.15. SWITCHES S2 THROUGH S5, S19, S20,

tation tab on switch is lined up with small hole in

AND S23 REPLACEMENT.

panel next to switch mounting hole.

NOTE

e. Solder (item 7, Appendix C) wires to switch.

Remove tags.

Procedure is typical.

Do paragraph 5.20.

Do paragraph 5.3.

5.17. SWITCH S24 REPLACEMENT.

b. Tag and unsolder wires from rotary switch S2

(14, Figure 5-2).

Do paragraph 5.3.

Loosen screws fastening knob to switch S2 shaft.

b. Tag and unsolder wires from switch S24 (34, Fig-

ure 5-2).

d. Remove nut and washer fastening switch to panel

(1).

c. Remove nut, washer, and keywasher fastening

switch to panel (1).

e. Install replacement switch to panel using washer,

and nut provided with switch. Make sure that antiro-

d. Install replacement switch to panel using key-

tation tab on switch is lined up with small hole in

washer, washer, and nut, provided with switch. Make

panel next to switch mounting hole.

sure that antirotation tab on switch is lined up with

small hole in panel next to switch mounting hole.

f. Solder (item 7, Appendix C) wires to switch.

Remove tags.

e. Solder (item 7, Appendix C) wires to switch.

Remove tags.

g. Turn switch shaft fully counterclockwise.

Do paragraph 5.20.

h. Install knob to switch shaft by tightening screw

on knob.

5.18. TRANSFORMER T1 REPLACEMENT.

Do paragraph 5.3.

Do paragraph 5.20.

5.16.

SWITCHES S6, S7, S9 THROUGH S14,

b. Remove screws, washers, and nuts (55) fastening

S17, S18, S21, AND S22 REPLACE-

bracket (56, Figure 5-2) to support assembly (46).

MENT.

c. Tag and unsolder wires from transformer T1 (59)

NOTE

terminals.

Procedure is typical.

d. Remove washers and nuts (58) fastening trans-

former T1 to bracket (56).

Do paragraph 5.3.

e. Install replacement transformer T1 to bracket

b. Tag and unsolder wires from rotary switch S6

using washers and nuts (58).

(10, Figure 5-2).

f. Solder (item 7, Appendix C) wires to terminals of

c. Remove nut and washer fastening switch to panel

transformer. Remove tags.

(1).

g. Install screws, washers, and nuts (55) fastening

d. Install replacement switch to panel using washer

bracket to support assembly.

and nut provided with switch. Make sure that antiro-

5-8