SECTION I. INTRODUCTION - TM-11-6625-3042-24P0005

TM 11-6625-3042-24P

SECTION I

INTRODUCTION

1. Scope

This manual lists and authorizes spares and repair parts; special tools; special test, measurement, and

diagnostic equipment (TMDE); and other special support equipment required for performance of organi-

zational, direct support, and general support maintenance of the TS-265A/UP. It authorizes the requisitioning,

issue, and disposition of spares, repair parts and special tools as indicated by the source, maintenance and

recoverability (SMR) codes.

2. General

This Repair Parts and Special Tools List is divided into the following sections:

a. Section II. Repair Parts List. A list of spares and repair parts authorized by this RPSTL for use in the

performance of maintenance. The list also includes parts which must be removed for replacement of the

authorized parts. Parts lists arecomposed of functional groups in ascending numeric sequence, with the parts

in each group listed in ascending item number sequence. Figure numbers are listed directly beneath the

group header.

b. Section III. Special Too/s List. Not applicable.

c. Section IV. /Vational Stock Nurnber and Part Nurnber Index. A list, in National item identification number

(NIIN) sequence, of all National stock numbered items appearing in the listing, followed by a list in alphameric

sequence of all part numbers appearing in the listings. National stock numbers and part numbers are

cross-referenced to each illustration figure and item number appearance.

3. Explanation of Columns (Section II and III)

a. Iterm No. (Column (1)). Indicates the number used to identify items called out in the illustration.

b. SMR Code (Column (2)). The source, maintenance, and recoverability (SMR) code is a five-position code

containing supply/requisitioning information, maintenance category authorization criteria, and disposition

instruction, as shown in the following breakout:

NOTE

Complete repair: Maintenance capacity, capability, and authority to perform

all corrective maintenance tasks of the "Repair" function in a use/user

environment in order to restore serviceability to a failed item.

(1) Source code. The source code tells you how to get an item needed for maintenance, repair, or

overhaul of an end item/equipment. Explanations of source codes follows: