|
|
TM 11-5895-1092-24P
SECTION I
INTRODUCTION
Code
Definition
1.
Scope
PA- Item procured and stocked for anticipated or known
This manual lists spares and repair parts; special tools;
usage.
special test, measurement, and diagnostic equipment
PB-Item procured and stocked for insurance purpose
(TMDE), and other special support equipment required
because essentiality dictates that a minimum
for performance of organizational, direct support, and
quantity be available in the supply system.
general support maintenance of the CV-3200/TSC and
PD-Support item, excluding support equipment, procured
CV-3199/TSC. It authorizes the requisitioning and issue
for initial issue or outfitting and stocked only for
of spares and repair parts as indicated by the source and
subsequent or additional initial issues or
maintenance codes.
outfittings. Not subject to automatic
2.
General
replenishment.
This Repair Parts and Special Tools List is divided into
MD-Item to be manufactured or fabricated at the depot
the following sections:
maintenance level.
XA-Item is not procured or stocked because the
and repair parts authorized for use in the performance of
requirements for the item will result in the
maintenance. The list also includes parts which must be
replacement of the next higher assembly.
removed for replacement of the authorized parts. Parts
XB-Item is not procured or stocked. If not available
lists are composed of functional groups in numeric
through salvage, requisition.
sequence, with the parts in each group listed in figure
XD-A support item that is not stocked. When required,
and item number sequence.
item will be procured through normal supply
b. Section III. Special Tools List. Not applicable.
channels.
NOTE
Number Index. A list, in National item identification
Cannibalization or salvage may be used
number (NIIN) sequence, of all National stock numbers
as a source of supply for any items
(NSN) appearing in the listings, followed by a list, in
source coded above except those coded
alphameric sequence, of all part numbers appearing in
XA and aircraft support items as
the listings. National stock numbers and part numbers
restricted by AR 700-42.
are cross-referenced to each illustration figure and item
(2) Maintenance code. Maintenance codes are
number appearance.
assigned to indicate the hlvels of maintenance
3.
Explanation of Columns
authorized to USE and REPA IR support items. The
a. Illustration. This column is divided as follows:
maintenance codes are entered in the third and fourth
(1) Figure number. Indicates the figure number of
positions of the Uniform SMR Code format as follows:
the illustration on which the item is shown.
(a)The maintenance code entered in the third
(2) Item number. The number used to identify item
position will indicate the lowest maintenance level
called out in the illustration.
authorized to remove, replace, and use the support item.
b. Source, Maintenance, and Recoverability (SMR)
The maintenance code entered in the third position will
Codes.
indicate one of the following levels of maintenance:
(1) Source code. Source codes indicate the manner
Code Application/Explanation
of acquiring support items for maintenance, repair, or
O-Support item is removed, replaced, used at the
overhaul of end items. Source codes are entered in the
organizational level.
first and second positions of the Uniform SMR Code
F-Support item is removed, replaced, used at the direct
format as follows:
support level.
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |