4931-01-072-1057)">
|
|
TM 9-4931-528-34P
Section I. INTRODUCTION
1. Scope. This manual lists spares and repair parts that
(2) Item Number.
The number used to
are required for maintenance of Test Fixture, Weinschel
identify each item called out in the list.
Model 4300B. It authorizes the requisitioning and issue
of spares and repair parts as indicated by the source
b. Source,
Maintenance,
and
Recoverability
and maintenance codes.
(SMR) Codes.
2. General. This repair parts and special tools list
(1) Source Code. Source codes indicate the
(RPSTL) is divided into the following sections:
manner of acquiring support items for maintenance,
repair, or overhaul of end items. Source codes are
entered in the first and second positions of the uniform
and repair parts authorized for use in the performance of
SMR code format as follows:
maintenance. The list also includes parts which must be
removed for replacement of the authorized parts. Parts
Code
Definition
are listed in alphabetical sequence within each figure
number.
PA-
Item procured and stocked for anticipated
or known usage.
b. Section III. Special Tools List. Not applicable.
(2) Maintenance Code. Maintenance codes
c. Section IV. National Stock Number and Part
are assigned to indicate the levels of maintenance
Number Index. A list, in National item identification
authorized to USE and REPAIR support items. The
number (NIIN) sequence, of all National stock numbers
maintenance codes are entered in the third and fourth
(NSN's) appearing in the listings, followed by a list in
positions of the uniform SMR code format as follows:
alphanumeric sequence of all part numbers appearing in
the listings.
NSN's and part numbers are
(a) The maintenance code entered in
cross-referenced to the figure and item number
the third position will indicate the lowest maintenance
appearance.
level authorized to remove, replace, and use the support
item. This position will contain the following code:
3. Explanation of Columns
Code
Application/Explanation
a. Illustration. This column is divided as follows:
H-
Support item is removed, replaced, and
(1) Figure Number.
Indicates the figure
used at the general support level.
number of the item shown.
(b)
The maintenance code entered in the
fourth position indicates whether the item is to be
repaired and identifies the lowest maintenance level with
the capability to perform complete repair
(i.e, all
authorized maintenance functions). This position will
contain one of the following maintenance codes:
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |