|
| |
TM 55-6695-220-13&P
CHAPTER 3. AVIATION INTERMEDIATE MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT
3-1.
COMMON TOOLS AND EQUIPMENT.
3-1
a.
Tool Kit JTK-17 For 68F Aircraft Electrician And 35H Calibration Repair Specialist. This kit contains hand tools
necessary for Intermediate Maintenance of Pyrometer and Thermocouple Tester. The services of a 35H Calibration
Repair Specialist will be required to recalibrate the tester after the replacement of some major components.
b.
Site And Shelter Requirements. The Pyrometer and Thermocouple Tester was designed for field use. Protection
of the tester from direct rain and excessive wind-blown dirt is mandatory for reduced maintenance requirements.
3-2.
SPECIAL TOOLS TMDE AND SUPPORT EQUIPMENT.
3-2
No special tools or support equipment are required for testing the Pyrometer and Thermocouple Tester. The
following TMDE equipment is required for testing and calibrating the Pyrometer and Thermocouple Tester:
a.
Voltage And Resistance Measurement-Hewlett Packard 6-1/2 Digit Multi-meter Model 3490 or equivalent with 0.1
microvolt and 0.1 milliohm resolutions.
b.
Resistance Source-Biddle Gray Decade Resistance Box Model 71650 or equivalent with 10 milliohm steps and
±.05% accuracy.
c.
Regulated DC Power Supply-NJE CS36CR30 or equivalent, 0-20 volts, .01% regulation.
3-3.
REPAIR PARTS.
3-3
Repair parts are listed and illustrated in Appendix C of this manual.
3-1
|
