TM56625-2694-13&P
The
appropriate work time figures will be shown for each level.
number of man-hours specified by the work time figure represents the
average time required to restore an item (assembly, subassembly,
module, end item, or system) to a serviceable condition
component,
includes
under typical field
This time
conditions.
operating
preparation time, troubleshooting time, and quality assurance/quality control time, in addition
to the time required to perform the specific tasks identified for the maintenance functions
authorized in the maintenance allocation chart. The symbol designations for the various
maintenance levels are as follows:
C----- Operator or Crew
O -----Organizational Maintenance
F ----Direct Support Maintenance
H -----General Support Maintenance
D -----Depot Maintenance
e. Column 5, Tools and Equipment. Column 5 specified, by code,
those common tool sets
(not individual tools) and special tools, test
and support equipment required to perform the designated function.
f.
Column 6, Remarks.
This column contains a letter code in
alphabetical order which is keyed to the remarks contained in Section
IV.
B-4 Column Entries Used in Tool and Test Equipment Requirements.
Column 1, Tool or Test Equipment Reference Code. The tool
a.
with a maintenance
and test equipment reference code correlates
function on the identified end item or component.
b.
Column 2 , Maintenance Level.
level
of
The lowest
maintenance authorized to use the tool or test equipment.
c. Column 3, Nomenclature.
Name or identification
of the tool
or test equipment.
d. Column 4, National\NATO Stock Number.
NATO
The National or
stock number of the tool or test equipment.
column 5, Tool Number.
e.
The manufacturer's part number.
B-3
Change 1